VocoPro UHF-3800 Operations Instructions download pdf (Page 10)

1. GRILL - Protects the microphone cartridge and helps reduce "breathy" and wind noise pick- up.

2. POWER switch - Used to turn the microphone ON/OFF and place in STANDBY.

3. BATTERY COMPARTMENT lid - Removable lid hides and protects the microphone battery.

4. CHANNEL selector (internal) - Used to sync the Mic transmitters outgoing frequency with the  

 receivers channels pre-set for Mic operation. For each Mic (A-B), the channel setting must be  

 set to the same number on the Mic as it is on the receiver. For example, MIC's A and B = Mic  

 channel setting 1, Receiver channel setting = 1.

5. ANTENNA terminal - Accepts the Mic transmitter ANTENNA used for UHF transmission.

Handheld Microphone Antenna Installation

1. Screw the ANTENNA into the ANTENNA TERMINAL on the bottom of each Mic transmitter.

Handheld Microphone Battery Installation

2. Unscrew the microphones BATTERY COMPARTMENT LID located at the bottom

of the microphone.

3. Insert 2 fresh 1.5-volt alkaline BATTERIES, being sure to observe proper battery polarity.

4. Re-tighten the BATTERY COMPARTMENT LID.

LED

ANT.

MIC

ON OFF

STANDBY

STICKER ON MIC

OPEN

TO CHANGE BATTERY

& SELECT MIC CHANNEL

MIC AND RECEIVER CHANNEL

SETTINGS MUST BE SET TO

THE SAME CHANNEL

OPEN CLOSE

MIC

LED STATUS:

ORANGE: LOW

FLASHING: STANDBY

GREEN:ACTIVE

MODEL: UHF-3800

8-Channel Dual UHF Wireless Microphone System

1 3 5 2

BATTERY COMPARTMENT BATTERY LID

BATTERY COMPARTMENT CLOSED

BATTERY COMPARTMENT BATTERY

Microphone Descriptions and Functions

UHF-3800 Microphone

Battery Installation

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

No comments

VocoPro UHF-3800 Operations Instructions Page 10