VocoPro STUDIO-C1 Operations Instructions download pdf (Page 45)

Basic Operation

Playback using the external input (EXT. IN)

terminals

Press the EXT. IN button on the main unit or INPUT

MODE button on the remote control unit to switch

the external input.

When operating the remote control unit:

• Cancelling the external input mode:

Press the INPUT MODE or ANALOG button to switch to the

desired input mode ( page 47).

• The external input mode can be set for any input source. To

watch video while listening to sound, select the input source

to which the video signal is connected, then set this mode.

• If the subwoofer output level seems too high, set the “SW

ATT” surround parameter to “ON”.

NOTE:

• When the input mode is set to the external input (EXT. IN),

the surround mode (DIRECT, STEREO, HOME THX

CINEMA, STANDARD, 7CH STEREO, WIDE SCREEN or

DSP SIMULATION) cannot be set.

• In play modes other than the external input mode, the

signals connected to these terminals cannot be played. In

addition, signals cannot be output from channels not

connected to the input terminals.

Connect the headphone to the PHONES jack.

• The pre-out output (including the speaker output) is

automatically turned off when headphones are

connected.

NOTE:

• To prevent hearing loss, be careful not to raise the volume

level excessively when using headphones.

Listening over headphone

Press the MUTE button.

You can adjust the muting level ( page 118).

Turning the sound off temporarily

(MUTING)

• Use this to mute the audio output temporarily.

• Cancelling MUTING mode:

Press the MUTE button again, or press the VOLUME button on

the remote control, or adjust the volume up or down via the

front panel VOLUME knob.

AUTO

EXT.IN ANALOG

PCM DTS

The mode switches as shown below each time the

INPUT MODE button is pressed:

(Remote control unit)

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 207 208

Comments to this Manuals

No comments

VocoPro STUDIO-C1 Operations Instructions Page 45

Comments to this Manuals